setting cursor task 3D to 1D

[ditalupita]

hai guys..
i'm a beginner on BCI2000.. I want to use cursor task application on 1D, but when i'm following the tutorial, i figured out that the default setting is on 3D.. can you tell me, how to change to 1D or maybe 2D? And my last question, i think i've some dfficulties when i'm following mu rhythm tutorial, can somebody help me to understand that ? in particular spatial and linnear classfier... i hope someone made video tutorial about mu rhythm and cursor task BCI2000...

best regard

dita

[mellinger]

Hi,

the cursor task appearance may be 3D, but the tutorial setup is actually 2D, i.e. there is no cursor movement in Z direction. The CursorTask page on the BCI2000 wiki will tell you how to switch from 3D to 2D appearance if this is what you would like to do.

Also, there is an example on the CursorTask wiki page that will show you how to set up 1D feedback.

The "help" button in the BCI2000 configuration provides an easy way to navigate to a local copy of the BCI2000 wiki, and open the information regarding a certain parameter. Just click the "help" button once, and then click the name of the parameter in question.

In general, the recommended way to search for answers is to use the Google site search field on
http://www.bci2000.org/wiki/
Make sure to use the field and button at the top center, not the one at the top right, which is restricted to the wiki. Also make sure to enter words exactly as they appear in the BCI2000 configuration dialog, otherwise the search may fail.

You are welcome to contribute a video version of the tutorials if you think this might benefit other users.

Best regards,
Juergen

[ditalupita]

thanks for your quick respons..

i'll tell you about my experiment.. and i hope, you can correct me if i'm wrong

for initial session
1. signal source : emotiv
signal processing : Dummy signal processing
application : stimulus presentation
2. i display number 1, 2, 3 and 4 to tell the subject to move hands and feet. Number 1 to right hand, 2 to left hand, 3 to both hand and 4 to both feet. because i dunno how to change the picture like on tutorial.. i've search and i don't find picture that written left hand ect. can you tell me? or with display number is enough?

1.jpg (2.65 KiB) Viewed 7852 times

for analyzing data
1. i use offline anaysis like this

but, when i write states.StimulusCode == 0 , i've some error like this picture

can you tell me, what should i do? thanks

[mellinger]

Hi,

the error message says that you don't have enough data for the condition StimulusCode == 0. You will need to increase the inter-stimulus-interval (ITI) of your stimulus presentation to fix that.

HTH,
Juergen

[chezz]

hello ditalupita,

I am also trying to perform the same task using emotiv. Please let me know the values you entered into the source tab of the configuration window. It would be of great help.

Regards,
Chezz