bci2000.org BBS

I am trying to compile the code in Borland Builder 2007 but I am unable to locate the file gUSBamp.h. I might be overlooking something obvious but I've been looking for awhile now and I can't find it. Could you please direct me to it's location?

Thanks in advance,

Rebekah

Hello,
It should be located in BCI2000/src/extlib/gtec/gUSBamp.
If you are compiling with Borland 2007, then all of the paths should be set correctly already. When/how did you download the source code?
Thanks!
Adam

I've been downloading it over the past week file by file but I only downloaded the ones required by the BCI2000.bpg and all the files for the Measurement Computing DAQ. Is there a quicker way?

Thanks for your patience,

Rebekah

Rebekah,

There is a MUCH easier and preferred way! Check out this page:
http://www.bci2000.org/wiki/index.php/P ... e:Contents

and particularly this page:
http://www.bci2000.org/wiki/index.php/P ... ient_Setup

This tells you how to download BCI2000 source files, and compile them, etc.
Adam

Adam,

MUCH easier was an understatement!

Thanks so much,
Rebekah