National Instruments data acquisiton board

[EliGC]

Hello!

I would like to know if the National Instruments board NI PCI-6024-E works for the software BCI2000. I am developing a BCI as my thesis project.

Best regards,

Eliana Garcia Cossio

[gschalk]

Eliana,

The PCI-6024-E board should work with the "old" 6.9.x drivers. The newer MX drivers are also supported, but I personally do not have experience with them.

Gerv

[EliGC]

Thanks for your help. I was reading about the driver of PCI-6024-E and i saw that it works with 7.0.x driver. Do you think that we are going to have problems with this DAQ and the source module for NI?

Thanks again for your time and knowledge.

Eliana

[gschalk]

Eliana,

I am not sure whether it works with 7.0. However, this board is definitely supported by 6.9.x. Thus, while we cannot guarantee functionality for user-contributed source modules, this board should definitely work.

Gerv