Difference between revisions of "User Reference:IIRBandpass"

From BCI2000 Wiki
Jump to: navigation, search
 
(Parameters)
 
(6 intermediate revisions by 2 users not shown)
Line 1: Line 1:
 
==Synopsis==
 
==Synopsis==
 +
Design an IIR filter consisting of up to three parts (high-pass, low-pass and notch) and apply it as part of the signal-processing chain. To use it as a bandpass, specify the desired lower end of the band as a high-pass corner, and the desired upper end of the band as a low-pass corner.
  
Design an IIR filter consisting of up to three parts (high-pass, low-pass and notch) and apply it as part of the signal-processing chain.
+
==Authors==
 
+
Jeremy Hill
==Location==
 
Not yet released:  will be released at  http://{{SERVERNAME}}/svn/trunk/src/contrib/SignalProcessing/HilbertSignalProcessing/CustomIIRFilter.cpp
 
 
 
==Versioning==
 
===Authors===
 
Cristhian Potes, Jeremy Hill
 
 
 
===Source Code Revisions===
 
*Initial development:
 
*Tested under:
 
*Known to compile under:
 
*Broken since:
 
  
 
==Parameters==
 
==Parameters==
Line 46: Line 35:
  
 
==See also==
 
==See also==
[[User Reference:Filters]], [[Contributions:SignalProcessing]], [[Contributions:HilbertSignalProcessing]]
+
[[User Reference:Filters]], [[Contributions:HilbertSignalProcessing]]
  
[[Category:Contributions]][[Category:Signal Processing]]
+
[[Category:Filters]][[Category:Signal Processing]]

Latest revision as of 18:56, 23 May 2014

Synopsis

Design an IIR filter consisting of up to three parts (high-pass, low-pass and notch) and apply it as part of the signal-processing chain. To use it as a bandpass, specify the desired lower end of the band as a high-pass corner, and the desired upper end of the band as a low-pass corner.

Authors

Jeremy Hill

Parameters

HighPassCorner

High-pass cutoff frequency. The default is 0, which disables the high-pass.

HighPassOrder

Filter order for the high-pass. The default is 2. A value of 0 disables the high-pass.

LowPassCorner

Low-pass cutoff frequency. The default is 0, which disables the low-pass.

LowPassOrder

Filter order for the low-pass. The default is 4. A value of 0 disables the high-pass.

NotchCenter

Notch center frequency. The default is 0, which disables the notch filter.

NotchOrder

Filter order for the notch. The default is 4. A value of 0 disables the notch filter.

States

None.

See also

User Reference:Filters, Contributions:HilbertSignalProcessing