bci2000.org BBS

Hi, when use from channel 3 to channel 10 as signal channels. the first signal channel of BCI2000 defaults channel 1 of gtec rather than channel 3 of gtec. Actually, channel 1 on gtec is not used for signal channel. So how to correspond the gtec channel with BCI2000? Thank for your help

Hi,

I assume you have an USBamp. Please check out the documentation.

http://www.bci2000.org/wiki/index.php/U ... gUSBampADC

I am not exactly sure what you are asking, but I think you may need to modify the SourceChList parameter.


Gerv