Page 1 of 1
National Instruments data acquisiton board
Posted: 24 Jul 2008, 17:32
by EliGC
Hello!
I would like to know if the National Instruments board NI PCI-6024-E works for the software BCI2000. I am developing a BCI as my thesis project.
Best regards,
Eliana Garcia Cossio
6024-E
Posted: 24 Jul 2008, 18:20
by gschalk
Eliana,
The PCI-6024-E board should work with the "old" 6.9.x drivers. The newer MX drivers are also supported, but I personally do not have experience with them.
Gerv
Posted: 26 Jul 2008, 10:01
by EliGC
Thanks for your help. I was reading about the driver of PCI-6024-E and i saw that it works with 7.0.x driver. Do you think that we are going to have problems with this DAQ and the source module for NI?
Thanks again for your time and knowledge.
Eliana
7.0 drivers ...
Posted: 26 Jul 2008, 14:20
by gschalk
Eliana,
I am not sure whether it works with 7.0. However, this board is definitely supported by 6.9.x. Thus, while we cannot guarantee functionality for user-contributed source modules, this board should definitely work.
Gerv