bci2000.org BBS

I am a starter to BCI research using BP's actichamp EEG amplifier. I connected with bci2000, by using bat file with actichamp source's executable. When clicking Set config, system log prompts failed to get device handle.I really could use your help,plesase.

Hello hzong,

did you read the actiChamp's contribution page on the BCI2000 wiki?
https://www.bci2000.org/mediawiki/index ... :actiCHamp

The battery might be low, or actiCHampAmplifierID might be set to something other than 0.

Regards,
Juergen

Thanks a lot. At present, I have solved this problem by using RDAClient. Thanks again