use optional parameters of TMSiADC
Posted: 14 Nov 2015, 08:32
Hello!
We want to perform a SMR motor imagery neurofeedback training with our ANT Asalab amplifier and BCI2000. We downloaded the TMSIADC source component (TMSi.exe from the contributors) to connect our ampli with BCI (following this topic: http://www.bci2000.org/phpbb/viewtopic. ... tmsi#p8175).
At the wiki info about that source component are a few optional parameters that we want to "activate" to modify on the configuration console(e.g. TMSiBufferSizeInSampleBlocks or TMSiProcessPriority). How do we do?
Thanks,
Joanllo
We want to perform a SMR motor imagery neurofeedback training with our ANT Asalab amplifier and BCI2000. We downloaded the TMSIADC source component (TMSi.exe from the contributors) to connect our ampli with BCI (following this topic: http://www.bci2000.org/phpbb/viewtopic. ... tmsi#p8175).
At the wiki info about that source component are a few optional parameters that we want to "activate" to modify on the configuration console(e.g. TMSiBufferSizeInSampleBlocks or TMSiProcessPriority). How do we do?
Thanks,
Joanllo