bci2000.org BBS

Dear all,
Im quite new in BCI2000 but I think is great. Sadly I haven't been able to test it all with my current equipment.

Our laboratory just aquired an Ant Neuro EEgo amplifier, sadly there is still no support on your software for it.
I know there have been some cases of success using the TMi software, sadly it has not been my case. I was wondering if anyone has any pointer on how to start with this. Where to download the TMi.exe that I couldn't compile since some packages are missing.
Every help is more than welcome
David

TecMonterrey,

at least the ANT asa lab amplifiers [1] were identical to the TMSi amplifiers and thus would work with the BCI2000 TMSi source module (see discussion below).

http://www.bci2000.org/phpbb/viewtopic.php?t=669
http://www.bci2000.org/phpbb/viewtopic.php?t=1360
http://www.bci2000.org/phpbb/viewtopic.php?t=1332

If the new Ant Neuro EEgo amplifier are not identical anymore to the TMSi hardware, then you would need to program a source module using the EEgo specific SDK from ANT. Depending on the complexity of the SDK and your C++ skill this may be not too difficult to accomplish.

If you decide to pursue this, the first step would be to ask the ANT for this SDK. Please send me a link to the SDK (per private message) and I can give you the general directions on how to integrate the SDK into a BCI2000 source module.

Regards, Peter

[1] https://www.ant-neuro.com/products/asa-lab