I have a question concerning the AppConnector. I tried a lot before and read through this forum and the documentation, but I think it's time. So I*m using following setup:
Source: AmpServerPro
Operator: v.3.0.5
Filter: FieldTripBuffer
Application: DummyApplication
External Stimulus Software: e-Prime 2.0
So everything works surprisingly fine, except the UDP-connection between e-Prime and the AppConnector. e-Prime is sending a state (stimulus onset and offset) as string (littleEndian), like
Code: Select all
Trigger 1\n
Code: Select all
Wait for Connected
Load parameterfile "../parms/NU_BCI_Test_3.prm"
ADD STATE Trigger 8 0 0 0
Set config
Code: Select all
ADD WATCH Trigger AT 10.0.0.41:20230
I probably oversee something. But what?
All the best,
Emanuel