Page 1 of 1

Need help with Operator Scripting

Posted: 30 May 2014, 16:18
by ksp6

I wish to run a sequence of applications automatically by simply running a batch file. Here is the general flow:

Start Task 1 --> Wait until it is over --> Start Task 2 ... and so on

I am trying to do this using Operator Scripting. I am aware that I can set "Running" to 0 or 1 from the batch script. Can I set it in the Application module e.g. in the Process() or StopRun() methods? I am also open to other suggestions, if anyone thinks this isn't the best way to do this.

Thanks in advance.
- Kedar

Re: Need help with Operator Scripting

Posted: 02 Jun 2014, 16:06
by ksp6
I figured out a way to do this. Using GET STATE commands it is much easier to do what I wanted to do. I did not notice them earlier. Everything works fine.

- Kedar