Page 1 of 1

Information's sending

Posted: 05 Sep 2016, 12:31
by Paico
Hi I have sent messages through UDP but, I send parameters that are superfluous information,
making between readings of channel values have values of 0.
Is there any way to reduce the message sent to only send the value of the channels?

Thanks!

Re: Information's sending

Posted: 08 Sep 2016, 10:26
by pbrunner
Paico,

you can use the "ADD WATCH" command in the AppConnector scripting to specify the variable that are transmitted:

http://www.bci2000.org/wiki/index.php/T ... _Connector

Regards, Peter