Problem interfacing with BCI2000

Forum for discussion on different brain signals
Posts: 1
Joined: 08 Feb 2013, 23:20

Problem interfacing with BCI2000

Post by npjose » 08 Feb 2013, 23:51

How do i interface the brain signals acquired from eeg electrodes to BCI2000??????

Posts: 615
Joined: 28 Jan 2003, 12:37

Re: Problem interfacing with BCI2000

Post by gschalk » 09 Feb 2013, 07:32

You need one of the amplifiers listed on the web site.


Posts: 1
Joined: 06 Apr 2013, 08:02

Re: Problem interfacing with BCI2000

Post by taspaceem » 16 Apr 2013, 07:31

Dear BCI200 community,

I am new to BCI and I am using Epoc head set with the research edition and I am trying to test the P300 speller of BCI2000 with it but I have problems with the batch file that I created as the tutorial here ... atch_files, it doesnot work and it does not run to configure the Emotive. So any help please, Does any one used the p300 speller with Emotiv can help?

Thank you so much

Posts: 1163
Joined: 12 Feb 2003, 11:06

Re: Problem interfacing with BCI2000

Post by mellinger » 30 Apr 2013, 10:57

In order to debug your batch file, please open a command prompt, cd to the BCI2000/batch directory, and run the batch file from there. This will allow you to read any error messages resulting from the execution of the batch file.


Posts: 1
Joined: 18 Feb 2014, 04:10

Re: Problem interfacing with BCI2000

Post by nm99 » 18 Feb 2014, 04:23

I have a set of EEG signals collected for specific task ,but the EEG signals are in .GNT format and each reading has a .DAT file attached to it,but EEGlab does not support that format,neither can I find some converter which can convert it to the compatible format. the system used for this purpose was Galileo Mizar. Is there any alternative to this?
Thank you in advance!


Who is online

Users browsing this forum: No registered users and 1 guest