Hi,
I'm trying to perform an analysis of a P300 Visual Speller and I need to get some figures of the data. I've acces to raw data (files .dat created by the BCI2000 application). As long as I know, the processing steps are as follow:
*Spatial Filter (CAR or others)
*Dividing in epochs and averaging
*Classifcation
I need to get the data after the CAR Filter and the epochs aswell. Is there any way to acomplish this?
Thank you.
Regards, Alberto.
Data in each step of a Visuall P300 Speller
Re: Data in each step of a Visuall P300 Speller
Alberto,
BCI2000 provides the Offline Analysis tool for this purpose [1]. Alternatively you can import the data into MATLAB using the load_bcidat mex interface [2], or into other programs using the ASCII files that the BCI2000Export tool creates [3].
Regards, Peter
[1] http://www.bci2000.org/wiki/index.php/U ... e_Analysis
[2] http://www.bci2000.org/wiki/index.php/U ... _MEX_Files
[3] http://www.bci2000.org/wiki/index.php/U ... 2000Export
BCI2000 provides the Offline Analysis tool for this purpose [1]. Alternatively you can import the data into MATLAB using the load_bcidat mex interface [2], or into other programs using the ASCII files that the BCI2000Export tool creates [3].
Regards, Peter
[1] http://www.bci2000.org/wiki/index.php/U ... e_Analysis
[2] http://www.bci2000.org/wiki/index.php/U ... _MEX_Files
[3] http://www.bci2000.org/wiki/index.php/U ... 2000Export
-
- Posts: 10
- Joined: 28 May 2015, 05:15
Re: Data in each step of a Visuall P300 Speller
Hi again, Peter,
I've tried to use all of these options.
[1] Offline Analysis only allows me to plot the r-squared value or target/non-target stimulus for a given channel and time interval.
[2] I've sucessfully loaded the XXXXXX.dat file. But at this point, no processing is done. I only have the raw data.
[3] Same as [2]
So what I pretend is to get the data after the CAR SpatialFilter but before epoching, after epoching but before classifying and after classifying.
Regards, Alberto.
I've tried to use all of these options.
[1] Offline Analysis only allows me to plot the r-squared value or target/non-target stimulus for a given channel and time interval.
[2] I've sucessfully loaded the XXXXXX.dat file. But at this point, no processing is done. I only have the raw data.
[3] Same as [2]
So what I pretend is to get the data after the CAR SpatialFilter but before epoching, after epoching but before classifying and after classifying.
Regards, Alberto.
Re: Data in each step of a Visuall P300 Speller
Alberto,
try the BCI2000 P300 GUI that was bundled until v2.0 [1]. No guarantees that it will still work, but if you run that in MATLAB you have access to all intermediate steps.
[1] http://tinyurl.com/pokjwbr
Regards, Peter
try the BCI2000 P300 GUI that was bundled until v2.0 [1]. No guarantees that it will still work, but if you run that in MATLAB you have access to all intermediate steps.
[1] http://tinyurl.com/pokjwbr
Regards, Peter
Who is online
Users browsing this forum: No registered users and 13 guests